標準號：BS EN ISO 1873-1-1995
中文標準名稱：塑料.聚丙烯模塑和擠出塑料.第1部分:標示方法和技術要求的依據
英文標準名稱：Plastics. Polypropylene (PP) moulding and extrusion materials. Designation system and basis for specifications
標準類型：G31
發布日期：1995/12/15 12:00:00
實施日期：1995/12/15 12:00:00
中國標準分類號：G31
國際標準分類號：83.080.20
適用范圍：1 This part of ISO 1873 establishes a system of designation for polypropylene (PP) thermoplastic material, which may be used as the basis for specifications. 2 The types of polypropylene plastics are differentiated from each other by a classification system based on appropriate levels of the designatory properties a) tensile modulus of elasticity b) impact strength c) melt mass-flow rate (MFR) and on information about basic polymer parameters, intended application and/or method of processing, important properties, additives, colorants, fillers and reinforcing materials. 3 This part of ISO 1873 is applicable to all propylene homopolymers and to copolymers of propylene with a content of other 1-olefins of less than 50 % (m/m), as well as blends of polymers containing at least 50 % (m/m) of aforementioned polymers. It applies to materials ready for normal use in the form of powder, granules or pellets and to materials unmodified or modified by colorants, additives, fillers, etc. This part of ISO 1873 does not apply to propylene-based rubber. 4 It is not intended to imply that materials having the same designation give necessarily the same perform-ance. This part of ISO 1873 does not provide engineering data, performance data or data on processing conditions which may be required to specify a material for a particular application and/or method of processing. If such additional properties are required, they shall be determined in accordance with the test methods specified in part 2 of this International Standard, if suitable. 5 In order to specify a thermoplastic material for a particular application or to ensure reproducible processing, additional requirements may be given in data block 5 (see clause 3, introductory paragraph).