標準號：BS ISO 15563-1999
中文標準名稱：乙醇-氯苯輻射劑量測定系統(tǒng)的實施規(guī)程
英文標準名稱：Practice for use of the ethanol-chlorobenzene dosimetry system
標準類型：G04
發(fā)布日期：1999/8/15 12:00:00
實施日期：1999/8/15 12:00:00
中國標準分類號：G04
國際標準分類號：17.240
適用范圍：This practice covers the preparation, handling, testing, and procedure for using the ethanol-chlorobenzene dosimetry system to measure absorbed dose in materials irradiated by photons and electrons in terms of absorbed dose in water. The system consists of a dosimeter and appropriate analytical instrumentation. For simplicity, the system will be referred to as the ECB system. It is classified as a reference standard dosimeter (see Guide E 1261).This practice describes the titration analysis as a standard readout procedure for the ECB dosimeter. Other applicable readout methods (spectrophotometric, oscillo-metric) are described in Appendixes X1 and X2.This practice applies only to gamma rays, X rays, and high-energy electrons. This practice applies provided the following are satis-fied: The absorbed dose range shall be from 10 Gy to 2 MGy (1).The absorbed dose rate does not exceed 10 Gy s (2).For radionuclide gamma-ray sources, the initial photon energy shall be greater than 0.6 MeV. For bremsstrahlung photons, the initial energy of the electrons used to produce the bremsstrahlung photons shall be equal to or greater than 2 MeV. For electron beams, the initial electron energy shall be greater than 4 MeV (see ICRU Reports 34 and 35). Note 1—The lower limits of electromagnetic radiation energy given are appropriate for a cylindrical dosimeter ampoule of 12-mra diameter. Corrections for dose gradients across an ampoule of that diameter or less are not required. The ECB system may be used at energies of incident electrons lower than 8 MeV by employing thinner (in the beam direction) dosimeter containers (see ICRU Report 35).The irradiation temperature of the dosimeter should be within the range from -40℃ to 80℃.This standard does not purport to address all of the safety problems, if any, associated with its use. It is the responsibility of the user of this standard to establish appro-priate safety and health practices and determine the applica-bility of regulatory limitations prior to use.