標準號：SIS SS-ISO 2137-1990
中文標準名稱：石油產品．潤滑脂和凡士林．觸探試驗的測定
英文標準名稱：Petroleum products — Lubricating grease and petrolatum — Determination of cone penetration
發布日期：1990/6/6 12:00:00
實施日期：1999/12/31 12:00:00
適用范圍：1.1 Section one of this International Standard specifies four procedures for determination of the consistency of lubricating greases by measurement of the penetration of a standard cone. These procedures cover the measurement of unworked, worked, prolonged worked, and block penetrations. Penetrations up to 620 units may be measured.1.2 Section two of this International Standard specifies methods for the determination of the consistency of lubricating greases, when only small samples are available, by the use of cones a half or quarter scale of that used in Section one.The methods are applicable to greases having penetrations of 175 to 385 units with the standard cone and are intended for use only if the size of the test sample prevents the use of Section one.They are not intended to replace the full-scale penetration as described in Section one, although a conversion to full-scale penetrations is given in 13.2.NOTES1 Unworked penetrations do not generally represent the consistency of greases in use as effectively as do worked penetrations. The latter are usually preferred for inspecting lubricating greases.2 Penetration of block greases can be obtained on those products which are sufficiently h?rd to hold their shape. These greases generally have penetrations below 85 units.1.3 Section three of this International Standard specifies a method for the determination of the consistency of petrolatums by measurement of the penetration of a standard cone, having penetrations up to 300 units.This method may also be used to estimate the consistency of sl?ck waxes.1.4 Section four of this International Standard describes the calculation of results, precision data and the test report.