標準號：BS EN ISO 10846-2-2008
中文標準名稱：聲學和振動.彈性元件的振動-聲學傳輸性能的實驗室測量.第2部分:連續變換活動用彈性支架動態剛性的測定直接法
英文標準名稱：Acoustics and vibration - Laboratory measurement of vibro-acoustic transfer properties of resilient elements -Part 2: Direct method for determination of the dynamic stiffness of resilient supports for translatory motion
標準類型：Z32
發布日期：2008/9/30 12:00:00
實施日期：2008/9/30 12:00:00
中國標準分類號：Z32
國際標準分類號：17.140.01
引用標準：ISO 266;ISO 2041;ISO 5348;ISO 7626-1;ISO 10846-1;ISO 16063-21;ISO/IEC Guide 98-3
適用范圍：This part of ISO 10846 specifies a method for determining the dynamic transfer stiffness for translations ofresilient supports, under specified preload. The method concerns the laboratory measurement of vibrations onthe input side and blocking output forces and is called “the direct method”. The method is applicable to testelements with parallel flanges.Resilient elements, which are the subject of this part of ISO 10846, are those which are used to reduce- the transmission of vibration in the lower part of the audible frequency range (typically 20 Hz to 500 Hz) to a structure which may, for example, radiate unwanted fluid-borne sound (airborne, waterborne or others),and- the transmission of low-frequency vibrations (typically 1 Hz to 80 Hz), which may, for example, act uponhuman subjects or cause damage to structures of any size when vibration is too severe.NOTE 1 In practice, the size of the available test rig(s) can restrict the use of very small or very large resilient supports.NOTE 2 Samples of continuous supports of strips and mats are included in this method. Whether or not the sampledescribes the behaviour of the complex system sufficiently is the responsibility of the user of this part of ISO 10846.Measurements for translations normal and transverse to the flanges are covered in this part of ISO 10846.The direct method covers the frequency range from 1 Hz up to a frequency fUL, which is usually determinedby the test rig.NOTE 3 Because of the large variety of test rigs and test elements, fUL is variable. In this part of ISO 10846, theadequacy of the test rig is not defined for a fixed frequency range, but on the basis of measured data, as described in 6.1to 6.4.The data obtained according to the method specified in this part of ISO 10846 can be used for the following:- product information provided by manufacturers and suppliers;- information during product development;- quality control;- calculation of the transfer of vibration energy through isolators.