標準號：ANSI Z400.1/Z129.1-2010
中文標準名稱：美國國家工作場所危險化學品–危害評估和安全數據表和預防標簽準備標準
英文標準名稱：American National Standard for Hazardous Workplace Chemicals – Hazard Evaluation and Safety Data Sheet and Precautionary Labeling Preparation
標準類型：G09
發布日期：2010/5/28 12:00:00
實施日期：2010/5/28 12:00:00
中國標準分類號：G09
適用范圍：This Standard applies to the preparation of SDSs and precautionary labeling for hazardous chemicalsused under occupational conditions. It presents basic information on how to develop and write SDSs andprecautionary labels. It also identifies information that must be included to comply with the HCS.Additional information is provided to help comply with state and federal environmental and safety lawsand regulations. Elements of this Standard may also be acceptable for international use. This Standardis not intended to address the distribution of SDSs.This Standard is not intended to provide a rote specification for complying with the HCS or any othergovernment requirements. Safety data sheet and precautionary labeling requirements and definitions aresubject to change. It is the responsibility of the SDS and label preparer to be aware of current HCSrequirements.This Standard must be applied in a manner consistent with all statutory and regulatory requirements,including the United States Occupational Safety and Health Administration (OSHA) HazardCommunication Standard (HCS; 29 CFR 1910.1200) and the substance specific standards (29 CFR1910.1001-1052).There are use-specific statutory and regulatory requirements for some chemical products that are outsidethe scope of OSHA HCS and therefore may have different SDS and/or labeling requirements. Someexamples include:? consumer products regulated by the Federal Hazardous Substances Act (FHSA),? medical products regulated by the Federal Food, Drug and Cosmetic Act (FFDCA),? pesticides regulated by the Federal Insecticide, Fungicide and Rodenticide Act (FIFRA),? materials in transportation regulated by the Department of Transportation (DOT) HazardousMaterials Regulations, and? laboratory chemicals regulated under 29 CFR 1910.1450, the “OSHA Laboratory Standard”.See 29 CFR 1910.1200(b) for information on the scope and application of the HCS.For example, a company that manufactures aspirin tablets does not need to produce and distribute SDSsto individuals that are taking aspirin to treat pain or some other medical condition. This includes aspirintablets taken by a worker in the workplace. In this scenario, the aspirin would fall under the jurisdiction ofthe FDA, not OSHA. However, the company would be required to produce OSHA hazard communicationdocuments (such as an SDS and labels) for workers who may be exposed to aspirin powder during themanufacture of the tablets.It is not the intent of this Standard to substitute for specific regulatory requirements or to list each andevery unique requirement. Where there is a conflict between the applicable regulations and thisStandard, the regulations must take precedence over this Standard. References to the Code of FederalRegulations (CFR) in the Standard are to the January 1, 2009 edition of the CFR.