標準號：BS EN 13598-1-2010
中文標準名稱：無壓力地下排水和排污用塑料管道系統.未增塑聚氯乙烯(PVC-U),聚丙烯(PP)和聚乙烯(PE).包括淺層檢驗室在內的輔助配件規范
英文標準名稱：Plastics piping systems for non-pressure underground drainage and sewerage. Unplasticized poly(vinyl chloride) (PVC-U), polypropylene (PP) and polyethylene (PE). Specifications for ancillary fittings including shallow inspection chambers
標準類型：Q81
發布日期：2011/3/31 12:00:00
實施日期：2011/3/31 12:00:00
中國標準分類號：Q81
國際標準分類號：93.030
適用范圍：This European Standard specifies the definitions and requirements for ancillary fittings of unplasticized poly(vinylchloride) (PVC-U), polypropylene (PP), and polyethylene (PE) intended to be used in non-pressure undergrounddrainage and sewerage systems, conforming to EN 476:a) outside the building structure (application area code “U”), reflected in the marking of products by “U”, andb) both buried in ground within the building structure (application area code “D”) and outside the building structure(application area code “U”), reflected in the marking of products by “UD”.It also specifies the test parameters for the test methods referred in this standard.The ancillary fittings covered by this standard are the following:? sealed access fittings;? rodding point covers;? rodding tees;? mechanical saddles;? inspection chambers for shallow non-roadway applications to a maximum depth of 1,25 m.NOTE 1 Inspection chambers as defined in 6.1.3 of EN 476:1997 have a riser with a DN/ID less than 800 mm.NOTE 2 Deep inspection chambers and manholes for application area U are specified in Part 2 of this standard.The fittings can be manufactured by various methods e.g. injection moulding, rotational moulding, spiral winding orfabricated from components made to other standards.The jointing can be with:? elastomeric ring seal joint;? cemented joint for PVC-U;? welded joint for PP and PE.NOTE 3 Pipes, fittings and other components conforming to any of the plastics products standards listed in Clause 2 can beused with ancillary fittings conforming to this standard, provided they conform to the requirements for joint dimensions given inClause 6 and to the requirements of Table 6.