標準號：BS EN ISO 9614-2-1997
中文標準名稱：聲學.利用聲強度對噪聲源聲功率級別的測定.使用掃描測量法
英文標準名稱：Acoustics. Determination of sound power levels of noise sources using sound intensity. Measurement by scanning
標準類型：Z32
發布日期：1997/4/15 12:00:00
實施日期：1997/4/15 12:00:00
中國標準分類號：Z32
國際標準分類號：17.140.01
適用范圍：1 This part of ISO 9614 specifies a method for measuring the component of sound intensity normal to a measurement surface which is chosen so as to enclose the noise source(s) of which the sound power level is to be determined. Surface integration of the intensity component normal to the measurement surface is approximated by sub-dividing the measurement surface into contiguous segments, and scanning the intensity probe over each segment along a continuous path which covers the extent of the segment. The measurement instrument determines the average normal intensity component and averaged squared sound pressure over the dur-ation of each scan. The scanning operation may be performed either manually or by means of a mechan-ical system. Band-limited weighted sound power level is calcu-lated from the measured octave or one-third-octave band values. The method is applicable to any source for which a physically stationary measurement sur-face can be defined, and on which the noises gener-ated by the source under test and by other significant extraneous sources are stationary in time, as defined in 3.13. The source is defined by the choice of meas-urement surface. The method is applicable in situ, or in special-purpose test environments. This part of ISO 9614 specifies certain ancillary pro-cedures, described in annex B, to be followed in conjunction with the sound power determination. The results are used to indicate the quality of the deter-mination, and hence the grade of accuracy. If the in- dicated quality of the determination does not meet the requirements of this part of ISO 9614, the test procedure is to be modified in the manner indicated. This part of ISO 9614 does not apply in any frequency band in which the sound power of the source is found to be negative on measurement. 2 This part of ISO 9614 is applicable to sources situated in any environment which is neither so vari-able in time as to reduce the accuracy of the meas-urement of sound intensity to an unacceptable degree, nor subjects the intensity measurement probe to gas flows of unacceptable speed or un-steadiness (see 5.2.2, 5.3 and 5.4). In some cases it will be found that the test conditions are too adverse to allow the requirements of this part of ISO 9614 to be met. Extraneous noise levels may exceed the dynamic capability of the measuring in-strument or may vary to an excessive degree during the test. In such cases the method given in this part of ISO 9614 is not suitable for the determination of the sound power level of the source. NOTE 1 Other methods (e.g. determination of sound power levels from surface vibration levels as described in ISO/TR 7849) may be more suitable.