標準號：ANSI/ASTM D5934-1997
中文標準名稱：用三點彎曲法測定在裝載控制速度下剛性和半剛性塑料樣品彈性模量的方法
英文標準名稱：Test Method for Determination of the Modulus of Elasticity for Rigid and Semi-Rigid Plastic Specimens by Controlled Rate of Loading Using Three Point Bending
標準類型：G31
發布日期：1999/12/31 12:00:00
實施日期：1997/3/5 12:00:00
中國標準分類號：G31
國際標準分類號：83.040.01
適用范圍： This test method covers the use of controlled rate of loading mechanical instrumentation for gathering and reporting the modulus of elasticity of thermoplastic and thermosetting resins and composite systems in the form of rectangular bars molded directly or cut from sheets, plates, or molded shapes. The data generated, using three-point bending techniques, may be used to identify the thermomechanical properties of a plastics material or composition using a controlled rate of loading mechanical instrument. Results obtained from this test method may or may not be comparable to results obtained using D 790. This test method is intended to provide a means for determining the modulus of elasticity within the linear region of the stress-strain curve (see Fig 1). This test is conducted at standard temperature and pressure. Apparent discrepancies may arise in results obtained under differing experimental conditions. These apparent differences from results observed in another study can usually be reconciled, without changing the observed data, by reporting in full (as described in this test method) the conditions under which the data were obtained. The values stated in SI units are to be regarded as the standard. The values stated in parentheses are for information only. This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. Note 1 -There is no similar or equivalent ISO standard.