標準號：IEC 61290-11-1-2008
中文標準名稱：光學放大器.試驗方法.第11-1部分:偏振模式分散參數.瓊斯矩陣特征分析法(JME)
英文標準名稱：Optical amplifier - Test methods - Part 11-1: Polarization mode dispersion parameter - Jones matrix eigenanalysis (JME)
標準類型：M33
發布日期：1999/12/31 12:00:00
實施日期：1999/12/31 12:00:00
中國標準分類號：M33
國際標準分類號：33.180.30
引用標準：IEC/TR 61282-9;IEC/TR 61292-5
適用范圍：This part of IEC 61290 applies to all commercially available optical amplifiers (OAs), includingoptical fibre amplifiers (OFAs) using active fibres, semiconductor optical amplifiers (SOAs),and planar waveguide optical amplifiers (PWOAs).Polarization-mode dispersion (PMD) causes an optical pulse to spread in the time domain.This dispersion could impair the performance of a telecommunications system. The effect canbe related to differential group velocity and corresponding arrival times of differentpolarization components of the signal. For a narrowband source, the effect can be related toa differential group delay (DGD) between pairs of orthogonally polarized principal statesof polarization (PSP). Other information about PMD may be found in IEC 61282-9 in generaland in IEC 61292-5 on OAs in particular.This test method describes a procedure for measuring the PMD of OAs. The measurementresult is obtained from the measurement of the normalized Stokes parameters at two closelyspaced wavelengths.The test method described herein requires a polarized signal at the input of the polarimeterwith a degree of polarization (DOP) of at least 25 %. Although the test source is highlypolarized, the DOP at the output of the OA is reduced by amplified spontaneous emission(ASE). Annex A analyses the impact of ASE on the DOP. In order to assure an accuratemeasurement, the DOP is measured as part of the measurement procedure.The method described herein has been shown to be immune to polarization-dependent gain(PDG) and polarization dependent loss (PDL) up to approximately 1 dB.Although the Jones matrix eigenanalysis (JME) test method is in principle also applicable tounpumped (that is, unpowered) OAs, the JME technique in this standard applies to pumped(that is, powered) OAs only.